Curb flashing
Wall and curb flashing is resecured or replaced where most leaks start.
A roofing contractor in Secaucus can repair commercial roof leaks at seams, curbs, drains and penetrations, so the next storm does not reach tenants. Call (551) 373-3020 to reach a local roofer.
Commercial roof leaks come from a short list of places. Curbs under rooftop units, pipe penetrations, pitch pans, roof drains, scuppers, wall flashing and coping caps are where most water gets in. Punctures from service work on rooftop units are another common cause, since technicians kneel, drop screws and set panels on the membrane.
Finding the leak takes more than looking above the stain. It runs along steel deck flutes, across insulation and down beams before it shows up on a ceiling tile. A roofer uses the interior location, the roof layout, seam probing, moisture meters and sometimes infrared scans or water testing to find the source.
Before the roofer arrives, protect what is below the leak. Move inventory, equipment and furniture away from the drip, catch water in buckets and keep it away from lights, outlets and electrical panels. Saturated ceiling tiles can be lowered carefully, and a sagging drywall ceiling drained through a small hole away from fixtures. Stay off the roof until the weather clears and a roofer can go up safely.
Depending on what the roofer finds, commercial roof repair in Secaucus, NJ can go hand in hand with commercial roof maintenance and tpo roof repair.
Looking for Secaucus commercial roof repair? Call (551) 373-3020 to talk to a local roofer.
Call nowGood repairs fix the source, not just the symptom.
Interior leak locations are noted and matched to the roof. It points the search to the right area of the roof.
The roofer checks every seam, curb, drain and penetration near the leak area. A water test can confirm the source when it is unclear.
The insulation near the leak is checked for moisture. Wet areas are removed and new insulation installed.
The repair uses material that matches the roof: welded patches on TPO or PVC, primer and seam tape on EPDM, new plies on mod bit or built-up roofs. Temporary sealant can stop a leak in a storm, but the permanent repair follows.
The roofer clears drains and checks for ponding near the leak. Ponding problems may need crickets or added drains.
The roofer notes what was found and fixed, with locations on a roof plan. Over time, the log shows patterns that guide maintenance.
Wall and curb flashing is resecured or replaced where most leaks start.
Drains, scuppers and gutters are cleared and repaired to stop backups.
Perimeter metal is reattached to keep water out of walls.
Punctures from service work are repaired with welded or adhered patches.
Open seams are welded, taped or resealed so water cannot enter.
Commercial roof leak repair is about stopping water first, then fixing the true source. In a storm, a roofer may apply a temporary seal or cover once it is safe to be on the roof. The lasting fix is done in dry conditions with compatible materials.
Property managers in Secaucus should flag leaks over sensitive areas so they are handled first. Letting the roofer know which spaces are sensitive helps set priorities. Note the time, place and weather of each leak.
Repair methods for commercial flat roofs vary by system. Welded patches suit TPO and PVC, tape and primers suit EPDM, and asphalt plies suit mod bit and built-up roofs. Incompatible repairs tend to fail quickly.
Ponding is a constant issue on flat roofs in Secaucus, and repairs often include improving drainage. Crickets, tapered insulation or new drains move water off. Long-standing water ages the roof faster.
Warehouse roofs are large and often hard to inspect, with leaks that can travel far. Metal warehouse roofs leak at fasteners, laps, ridge caps and old skylight panels. Membrane warehouse roofs leak at seams, curbs and drains.
In Secaucus, warehouse roof repairs often need to protect goods and keep loading docks open. Protecting goods below and working around shipping schedules is part of the job. Skylights are a fall hazard on warehouse roofs, so they are protected or avoided during work.
In Secaucus, building owners and managers often call after a storm or after HVAC work on the roof. Buildings in Secaucus and around Union City, East Rutherford, West New York and North Arlington see heavy rain, sun and occasional strong storms that test drains and details, so keeping drains clear and flashings sound prevents many calls.
Need commercial roof repair around Secaucus? Call (551) 373-3020 for a Secaucus roofer who serves the towns around it too.
Winters here are long and cold, with snow on the roof for weeks at a time and plenty of nights below freezing. Heat escaping from the attic melts snow on the upper roof, and the water refreezes at the colder eaves, which is how ice dams form and back water up under the shingles. Coastal storms and heavy spring rain drive water sideways into flashing, valleys and old chimneys. That is why roof repair in Secaucus is busiest after a hard winter and before the next one.
A roof problem fixed early rarely spreads to the decking, the insulation or the ceilings.
Roofers in Secaucus know the roof types and weather wear common in local homes.
Ask your questions before you agree to anything.
More questions? Call (551) 373-3020
Scheduled inspections, drain clearing and small repairs for commercial roofs, that help the roof reach its full life.
Learn moreTPO roof repairs welded with matching membrane, so the roof stays one continuous sheet.
Learn moreRepairs for leaking flat roofs, from punctures and seams to clogged drains and wet insulation, so the roof sheds water again without a full replacement.
Learn moreCoating systems that seal and reflect sun on commercial roofs, built to a measured thickness.
Learn moreLooking for something else?
See all roofing servicesCall (551) 373-3020 for a local roofer in Secaucus and nearby towns.